Archive for the ‘gear’ Category

2011 Australian Age Champs – Underwater shots…

Thursday, May 5th, 2011

It only seems like last year I blogged about this same event……hey, it was!!!

Get the Flash Player to see this content.

Thanks to Duane for SportingImages for helping arrange the access. Thanks to Matt and Murray for the setup help.

JetBlack 24 – MarathonPhotos event…

Tuesday, February 8th, 2011

For the 3rd year running I covered the JetBack24 endurance mountain bike event at Del Rio Resort Wisemans Ferry. The last 2 years its rained non-stop. This year it was 35, humid and mosquito infested. At least I could use my gear to its full potential without it getting wet.

The brief from James Rankin at Marathon Photos was to be creative. However, you need to get saleable shots. This means faces and race numbers. No point getting a super creative shot if no one can buy it. I tried to keep it simple this year, with just one off-camera flash and used the PocketWizard MiniTT1, the FlexTT5 and most of all the AC3 Zone Controller. What is all that? It mean full manual power control over a remote flash. If the light changes, you can change with it, while getting the consistency and reliability of manual flash power.

Location 1 – Shot#1

Camera Gear – 1DMK3, 28-300 – 135mm, OSI1000, f6.3 1/160
Flash – 580EX – Camera right behind a tree – Manual power – 1/64th

Location 1 – Shot#2

Camera Gear – 1DMK3, 28-300 – 50mm, OSI200, f4 1/200
Flash – 580EX – Camera right behind a tree – Manual power – 1/64th

Location 2 – Shot#1

Camera Gear – 1DMK3, 28-300 – 235mm, OSI1000, f5.6 1/160
Flash – 580EX – Camera left – Manual power – 1/64th +1/3

Location 2 – Shot#2

Camera Gear – 1DMK3, 15mm Fisheye, OSI1000, f10 1/40
Flash – 580EX – Camera left – Manual power – 1/64th +2/3
Twist the camera on a slow shutter for the effect.

Conclusion
* The 28-300 is a great versatile lens for mountain bike shooting. Its not too bad across the entire range and means I carry 2 lenses not 3 or 4.
* The PocketWizard Manual system works really well. eTTL fails in these events due to the changing light situations and vastly inconsistent results.
* Remote flash is the way to go. Get the flash close to the subject and it uses far less power. 600+ shots all day on one set of batteries, and 1/64 power.

New NVIDIA Quadro 5000 – No more renderring….

Wednesday, February 2nd, 2011

Bit the bullet and bought the NVIDIA Quadro 5000 GPU video card today. Its a MONSTER of a card at twice the physical width of my last video card and 5 cm longer. Its super powerful and allows me to apply GPU effects to Premiere Pro without the need to render each clip again.

NVIDIA Quadro 5000

WTF does all that mean….lets get the Adobe nerds to explain

Testing the Ikelite 5D MKII Housing….

Tuesday, January 11th, 2011

The last time I put a live camera in this housing, it flooded killing the 5D body. Thanks to the bright sparks at Ikelite, they neglected to install an O-Ring on the superwide port body leaving a gap for the ocean to fill. I’m stupid enough to have only tested the housing briefly by dunking it in the SPA for a few minutes. Not this time!!!!

Camera Dummy” – 2 dive weights (6 lb) wrapped in newspaper. A suitable camera analogue and the newspaper will easily show signs of water

Dummy Camera

Dummy Camera

Test 1 – 30 minuted in SPA with pump running.
Today I installed the dummy camera in the housing and left it in the SPA (15C) for 30 minuted with the pump running. I was not gentle with the housing holding it by the dome port to see if it would come lose. No water at all in the housing. Not a drop. Who would have thought that a correctly assembled housing would work.

SPA test - Pump running

SPA test - Pump running

SPA test - Pump not running

after a good wash-off

Test 2 – Dummy Scuba
With any luck, I’ll be diving Wednesday night off the boat. I’ll take the housing along to see if I can get it to leak. Dummy camera installed.

Test 3 – SPA with live camera

Test 4 – Shore (sure) dive with live camera

Go-Live

Annus horribilis – and its only just started….

Sunday, January 9th, 2011

The year has not started so well. I lost 4 days work when a HDD failed (My own stupid fault there), and now my new Ikelite housing flooded killing my 5D (again, my stupidity there).

What has this taught me…..Slow down and do things properly. Having all files in only one location is poor practice, and getting on a dive boat with a briefly tested housing is crazy.

Lets get back to doing things properly and with any luck the year will get better.